10 gpm 3500 psi Skid Cold Pressure Washer ONLY Honda Engine TSF2421

10 gpm 3500 psi Honda IGX800 General Pump TSF2421 BX Belt drive, special powder coated steel frame and 1/2" green spring high volume pressure trapped unloader

Standard features

• Lifetime frame warranty on powder coated steel frame
• 3/8" Coupler installed on the outlet of 1/2" unloader (reduced)
• 1/2" Brass barb installed on the bypass outlet (Need bypass hose AGY08)
• High flow 1/2" ported YU21405 green spring unloader
• Engine and pump oil drains 
• 20" L x 29" W x 20" H
• 178 Lbs
• Mounted on anti-vibration pads or hockey pucks
• Oil filter side exhaust
• Honda IGX800 Key Start Engine
• Safety relief valve
• 30W Non-Detergent oil for pump
• 10W30 oil for engine
• Oil prefilled in pump and engine
• Can not be shipped inside the state of California 

We highly recommend adding:

The best high pressure 3/8" ball valve (6292.SMB) to this order to allow you to turn off the high pressure flow of water to switch from the gun to a Whisper Wash Ground Force surface cleaner. You need 4 x 3.0 orifice 25 degree nozzles for a four tip bar (1769) or 2 x 6.5 orifice 25 degree nozzles for a two tip bar.

This unit will need 12.0 nozzles.

We carry everything you need to plumb this pressure washer in a kit which is part number, PL-8-TA for a horizontal leg tank or PL-8-TO for an IBC tote. You will need to add 10-15' of AGY08.  The kits do not include the bypass hose.

Choose a 12.0 turbo nozzle for this pressure washer. 

      Install a high temperature Hudson float valve (Hudson-HT) using everything you need to install it into your water tank with our Hudson Installation Kit (HB). The Hudson installation kit installs into the very top of the tank using a bulkhead and barb to prevent the tank from over-flowing.

• Add a fuel tank
• Try a Lori Lift Kit and make your life easier!  Lift your unit up.
• Need a gun, click here?
• Hose?