8.5 gpm 4000 psi Skid Cold Pressure Washer Honda Engine Annovi Reverberi XW30.28N

Pressure Washer Only

8.5 gpm 4200 psi Honda GX690 24 HP Annovi Reverberi XW30.28N Belt drive , powder coated steel frame and 1/2" blue spring high volume pressure trapped unloader

This unit is IN STOCK.  

Standard features

• Lifetime frame warranty on powder coated steel frame
• 3/8" Coupler installed on the outlet of 1/2" unloader (Reduced at outlet)
• 1/2" Brass barb installed on the bypass outlet (Need bypass hose AGY08)
• High flow 1/2" ported VRT100 unloader
• 4 x 3VX Belts
• Engine and pump oil drains 
• 29" L x 29" W x 20" H
• 185 Lbs
• Mounted on anti-vibration pads or hockey pucks
• Starter side exhaust
• Must add 2 or 4 AWG battery cables and battery/box
• Honda GX690 Key Start Engine w/ Honda 3 Year warranty
• Annovi Reverberi standard pump warranty
• Oil prefilled in pump and engine
• 30W Non-Detergent oil for pump (1.3 qts on average change)
• 10W30 oil for engine
• Can not be shipped inside the state of California 

We highly recommend adding:

The best high pressure 3/8" ball valve (6292.SM) to this order to allow you to turn off the high pressure flow of water to switch from the gun to a Whisper Wash Classic surface cleaner (4345W). You need 4 x 2.5 orifice 25 degree nozzles for a four tip bar (2812) or 2 x 4.5 orifice 25 degree nozzles for a two tip bar (1122).

This unit will need 8.5 or 9.0 nozzles and a 5 - 8 gpm 2.3 mm chemical injector assembly.

We carry everything you need to plumb this pressure washer in a kit which is part number, PL-8-TA for a horizontal leg tank or PL-8-TO for an IBC tote.  If buying the kit, you will need the 1/2" bypass barb.  You will need to add 10-15' of AGY08.  The kits do include the bypass hose. 

Choose a 9.0 turbo nozzle for this pressure washer. 

Do not adjust your unloader!

The unloader is set at a spike pressure of 200 psi above the operating pressure of the pump and meant to be left alone. If you need less pressure, change out the nozzles to a larger orifice and never smaller than what is called for using factory specifications using gpm and pressure. This unit requires a 8.5 orifice or larger. You can add a 6540-8 JROD kit to play with nozzle distances and pressures.

       Install a high temperature Hudson float valve (Hudson-HT) using everything you need to install it into your water tank with our Hudson Installation Kit (HB). The Hudson installation kit installs into the very top of the tank using a bulkhead and barb to prevent the tank from over-flowing.

• Add a fuel tank 
• Try a Lori Lift Kit and make your life easier!  Lift your unit up.
• Need a gun, click here?
• Hose?