Shopping security
Enhance your marine electronics setup with the Furuno NMEA 2000 Power Tee, a reliable accessory designed for seamless power distribution in NMEA 2000 networks. Featuring an 8-meter cable and dual female connectors, this power tee simplifies branching power from your main backbone to critical devices like chartplotters, radars, and sensors. Boat owners and installers appreciate its robust construction, which withstands harsh saltwater environments while ensuring stable data and power flow.
In the world of marine networking, reliable power management is key to uninterrupted performance. This Furuno Power Tee eliminates the clutter of multiple wiring runs by providing a clean, centralized point for injecting 12V DC power into your NMEA 2000 backbone. Its 8-meter length offers flexibility for installations on boats of various sizes, from compact center consoles to larger yachts. Unlike basic tees, Furuno's design incorporates high-quality Micro-C connectors that resist corrosion and vibration, common culprits in marine failures.
Installing this Power Tee takes minutes for experienced riggers but is approachable for DIY boaters too. Start by powering down your system and locating a suitable spot on the NMEA 2000 backbone, ideally near the power source or power insertion module. Connect the tee's male end to the backbone, then use the two female ports for incoming power (via a fused 12V line) and device drops. Secure with cable ties to avoid chafing, and test continuity with a multimeter before full power-up. For multi-branch setups, pair it with Furuno's backbone extenders to maintain signal integrity over distances up to 100 meters total network length.
Pro Tip: Always fuse the power input at 3-5 amps to protect against shorts, and label connections for future maintenance—saving hours during troubleshooting.
Fully compliant with the NMEA 2000 standard (IEC 61162-3), this tee works effortlessly with Furuno instruments like NavNet TZtouch series, as well as third-party gear from Lowrance, Garmin, and Simrad. It supports baud rates up to 250 kbps and handles up to 50 nodes per network segment. In Furuno ecosystems, it pairs perfectly with the IF-NMEA2K1 interface for legacy NMEA 0183 conversions, future-proofing your setup for PGN data sharing across autopilots, fishfinders, and engine monitors.
Whether you're outfishing, cruising coastal waters, or racing offshore, this Power Tee shines in demanding scenarios. On tournament bass boats, it powers multiple sonar units without signal loss. Sailors use it to branch VHF AIS receivers from the main bus. Commercial operators value its reliability for engine data feeds to remote displays. By centralizing power, it reduces wiring weight and complexity, letting you focus on the helm rather than electrical gremlins.
To maximize lifespan, inspect connectors annually for corrosion—clean with electrical contact cleaner and dielectric grease. Avoid exceeding 10A total draw through the tee, and monitor for backbone terminators at both ends to prevent reflections. In high-vibration areas like engine rooms, add strain relief. With proper care, expect years of trouble-free service in even the saltiest conditions.
An NMEA 2000 Power Tee injects 12V power into the network backbone at a branch point, allowing multiple devices to share power and data without daisy-chaining long drop cables that could cause voltage drops.
It features an 8-meter cable, providing flexibility for installations where the power source is not immediately adjacent to the backbone junction.
It includes one male connector for backbone attachment and two female connectors for power input and device drops, following standard NMEA 2000 conventions.
Yes, as a certified NMEA 2000 component, it works with any compliant devices from brands like Raymarine, B&G, or Honda digital engines.
It powers branches from the insertion point but requires a dedicated power cable (12-15V DC) connected to one female port. Use multiple tees or a power isolation engine for full networks.
Rated IP67 for dust and water submersion up to 1 meter, it's built to handle marine exposure including salt spray, humidity, and shocks.
No, it's plug-and-play with twist-lock Micro-C connectors. A crimper helps for custom power wires, but basics require just cable ties.
NMEA 2000 Power Tee - 8M - 2x Female Connector
Furuno's NMEA2000 Power Tee with 8 Meter, 2x Female connector.
Ships within 48 hours · Estimated delivery Jul 2 - Jul 7
US$40
Get nowSign up to your membership to get coupons up to
15%
Get nowOpportunity to enjoy order discount up to 15% off
Top-Converting Item to Boost Your Average Order