Are the fog light cutouts ready to use, or do I need to drill them out?

The fog light openings are pre-cut and ready for your 2.5" fog lights. Verify your existing fog light size against the 2.5" specification before installation to ensure proper fitment.

Do I need to check for lower valance or sensor compatibility before installing?

Yes. If your vehicle has factory parking sensors or lower bumper trim pieces, reference your OEM bumper hole locations and sensor placements before installation. The bumper cover uses factory mounting points, but any additional hardware or sensor integration should be confirmed with your vehicle's setup.

What finish should I apply to the surface?

Sand and prep the surface to your preferred grit before applying primer and paint. The choice of paint system — single-stage, base/clear, or specialty finishes — is entirely up to you. Ensure proper surface prep for adhesion and longevity.